How to trim down your vinyl fence panel for a custom fit.

This article addresses how to trim down your vinyl fence panels. We recommend prior to doing this that you first read this article on equalizing your fence sections. A. Measure distance between vinyl posts and cut to the measured length. B. Measure both top and bottom rail to ensure both are the same length before

read more

Share
 by Denise

How do I equalize my fence sections to fit my overall fence run?

Very rarely will your fence sections all fit perfectly into your fence line. You have three options. You must consider these three options before installing your first anchor. Please  note that the illustrations below are of vinyl fence panels, but the same principles apply for ornamental aluminum fence panels. BEST Solution A: Trim all fence

read more

Share
 by Denise

How do I compensate for anchors that have been pounded in severely crooked?

If your leveling donut will not allow for compensation of a severely crooked anchor, then you have at least three options. Option One: Drive the Anchor Deeper than Recommended B. Continue to pound the anchor deeper into the ground than what we typically recommend. This corrective ability of your leveling donut is amplified the closer

read more

Share
 by Denise

How do I deal with loose or disturbed soil?

Your pipe anchors, even when driven to the recommended depths of 36 inches AND 48 inches, will have a wind load resistance problem if the ground around them is unstable. If your entire fence line is located in loose or extremely loamy conditions, you can install our fence system much like you would if you

read more

Share
 by Denise

How do I deal with extremely hard or dry ground?

Option 1: Use water to loosen soil Outlined below are some additional things you can do if you still find pounding your anchor is going too slow. Option 2: Use concentrated water to loosen soil A. Pound anchor into ground as far as possible. B. Fill anchor to the top with water and let sit until water

read more

Share
 by Denise

How do I deal with rocks and other underground obstructions?

By far the most frustrating part of installing a fence is running into unforeseen obstacles under the ground. It doesn’t matter if you go the WamBam way or the traditional way- a big rock or tree root is going to cause you grief. Large Rocks? If the rock is large and stable enough it may

read more

Share
 by Denise

How do I determine if obstructions exist underground?

If you’re at all suspicious that you might run into some underground obstructions when installing your pipe anchors, we strongly encourage you to do some underground “investigating” prior to ordering your fence. It’s important to check your ground if you are concerned about rocks. There are some conditions that WamBam Fence won’t work in, such as

read more

Share
 by Denise

How do I deal with sloping ground for my vinyl fence?

There are two ways to tackle a vinyl fence line with ground that slopes either up or down. You can step or slope your vinyl fence as illustrated below. Because no other man-made vertical element in your backyard is generally installed with a noticeable slope, neither should your fence. However, this is just personal preference.

read more

Share
 by Denise

How do I determine the slope of my fence line?

Often the ground slope of your fence line will be much greater than you think it is. To understand how much of a fall your fence line has, run a level string line from the start to the finish of your fence line. You will need to compensate for this difference in height either equally

read more

Share
 by Denise
Categories